Idea 11 - Dies to be used with glassine and kraft liners which need the use of a step down anvil, then the job needs setting up again
2 posters
Page 1 of 1
Idea 11 - Dies to be used with glassine and kraft liners which need the use of a step down anvil, then the job needs setting up again
use onky dies for kraft OR glassine liner to save on excessive set-up times
Re: Idea 11 - Dies to be used with glassine and kraft liners which need the use of a step down anvil, then the job needs setting up again
This idea has been assigned to Damian and myself
Re: Idea 11 - Dies to be used with glassine and kraft liners which need the use of a step down anvil, then the job needs setting up again
Going to ask Bob to join us as the person who raised the idea. Anyone got any ideas who else would want to be involved.
Re: Idea 11 - Dies to be used with glassine and kraft liners which need the use of a step down anvil, then the job needs setting up again
15 minute meeting set up to understand the problem tomorrow at 15:45
Re: Idea 11 - Dies to be used with glassine and kraft liners which need the use of a step down anvil, then the job needs setting up again
Spoke to Carl Lee as well to help from an understanding the cost implications and he is up for it. We won't need him for the 1st meeting though. I will update him from the outcome
lnuttall- Posts : 6
Join date : 2016-05-24
Similar topics
» Idea 13 - Die adaptors with different cavity sizes, some don’t fit all dies and need to be swapped
» Idea 9 - Setting up 10" undercutters on press, lots of operators not sure how to set these up properly
» Idea 12 - When setting up and trying to run perf jobs with 8TPI the perf keepings snapping and then we change to 10TPI and it runs ok
» Idea 4 - Sims currently sourced from the US at a cost of 50p plus transport
» Idea 2 - Long walk between scale and computer
» Idea 9 - Setting up 10" undercutters on press, lots of operators not sure how to set these up properly
» Idea 12 - When setting up and trying to run perf jobs with 8TPI the perf keepings snapping and then we change to 10TPI and it runs ok
» Idea 4 - Sims currently sourced from the US at a cost of 50p plus transport
» Idea 2 - Long walk between scale and computer
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|